? coilcraft, inc. 2005 specifications subject to change without notice. please check our website for latest information. rfid transponder coil C da2339-al document 507 document 507 revised 10/20/05 inductance 2 read matching at 100 khz distance 3 sensitivity 4 capacitor 5 dcr max 6 srf typ 7 part number 1 2% (mh) q min 2 (inches/cm) (mv/ t) (pf) (ohms) (khz) da2339-al_ 0.20 7 tbd tbd tbd 16.1 9800 1. when ordering, please specify packaging code: da2339-al d packaging: d =13 machine-ready reel. eia-481 embossed plastic tape (3000 parts per full reel). b = less than full reel. in tape, but not machine ready. to have a leader and trailer added ($25 charge), use code letter d instead. 2. inductance and q measured using agilent/hp 4192a impedance analyzer at 100 khz. for recommended test procedures, contact coilcraft. 3. read distance measured using the keeloq ? transponder evaluation kit part number dm303005 from microchip. distance was recorded as the voltage across the resonant circuit dropped below 10 mv. 4. sensitivity measured in accordance with coilcraft application note ?measuring sensitivity of transponder coils.? 5. matching capacitor value required for parallel resonant circuit operating at 125 khz. 6. dcr measured on micro-ohmmeter. 7. srf measured using agilent/hp 8753d network analyzer. 8. operating temperature range ? 40c to +125c. 9. electrical specifications at 25c. see qualification standards section for environmental and test data. 0.10 0.002 2,54 0,05 0.10 2,54 0.33 8,38 0.56 14,22 0.16 4,06 0.12 3,05 0.32 8,13 recommended land pattern 0.536 13,61 0.15 3,81 0.084 2,13 0.002 0,05 unless specified, tolerance is 0.010 (0,25). xxx terminations: nickel/gold over phos bronze tape and reel: 3000/13 reel 24 mm tape width
|
